Ide Pata
2008
![]() |
![]() Startechcom PATA2SATA2 IDE SATA DRIVE MB ADAPTER US $25.85
|
![]() Ultra 2 Port IDE PATA PCI Expansion Card US $24.99
|
![]() 4 PORT IDE PATA RAID CONTROLLER US $24.99
|
![]() New PATA IDE TO SATA Adapter For 35 25 Hard Drive HDD US $8.71
|
![]() PATA IDE TO Serial ATA SATA Adapter Converter For HDD US $8.69
|
![]() SYBA Drive SATA to PATA IDE Card Converter Adapter US $8.69
|
![]() NEW PATA TO SATA ADAPTER CONVERTS IDE DEVICES TO SATA US $6.99
|
![]() PATA IDE To SATA Serial ATA Converter Adapter W Cable US $6.99
|
![]() PATA IDE TO SATA Adapter Converter Card For 35 HDD DVD US $4.98
|
![]() PATA IDE TO SATA Adapter Converter for 35 25 HDD DVD US $4.98
|
![]() Serial ATA SATA to 35 IDE HDD DVD CD HD PATA Converter US $4.69
|
![]() Serial ATA SATA to PATA IDE 133 100 Converter Adapter US $4.20
|
![]() 35 40 Pin PATA IDE to SATA Hard HDD Converter Adapter US $.99
|
IDE Hard Drive Error: 'No Fixed Disk Present'
A system might fail to detect an IDE hard drive if it is failed. Also, for an IDE hard drive to work properly, you should set the jumpers properly or else the drive will not work. An IDE hard drive is denoted as failed if either of its internal components, like read/write head, actuator, PCB etc.. stops working. Thus, to recover from such situations, you should call a professional Hard Drive Recovery service that helps extracting the lost data by repairing or replacing these damaged internals in safe surroundings. You might come across the below error message while starting a system installed with an IDE hard drive: “No fixed disk present”
Cause
The above error might root from any of the below reasons:
- You have recently installed a new IDE hard drive and the jumpers have not been properly set. In such conditions, the system will fail to properly boot.
- Your hard drive is not properly connected to the system. This might occur if you have recently moved your hard drive and have not connected the cables properly.
- Hard drive has not been defined in CMOS. This is sometimes a specific requirement in some of systems if doesn't have auto detect option.
- Hardware like hard drive, IDE cable or motherboard is physically damaged and hence system cannot boot.
Solution
Consider following these measures:
- Make sure that all the jumper on IDE hard drive and other devices are in correct configuration of master and slave.
- Check for the all cables that connect the hard drive to the system and motherboard
- Ensure proper CMOS settings
- Replace the damaged hard drive, IDE cable or motherboard. In case of hard drive, you will need to restore the lost data from backup that must be completely updated and clean to provide required results. Call Hard Drive Data Recovery service if you find concerns while restoring from backup.
Hard Drive Recovery is the professional assistance provided to recover data from physically crashed media like hard drive. The service includes fixing damaged internals, imaging the hard drive and applying several disk level techniques. Stellar Information Systems Limited is the providers of comprehensive Hard Drive Data Recovery service for IDE, SATA, EIDE, SCSI and PATA hard drives. The company has Class 100 Clean Rooms to offer safe data recovery. Stellar has rich experience and proven record in providing leading disk recovery service.
About the Author
Author is researching on the hard drive related problems and data loss conditions.Author has given solution of hard drive recovery and suggested to use hard drive recovery software.
Why is the new SATA standard faster than the old PATA/IDE?
Usually parallel connections are faster, why did the industry switch to serial ATA?
its the bandwidth and the red wire is a Xpress data wire. The design of SATA does not slow down when on high load. When you look at a hard drive meter it going very fast, but with pata it only going a few hundard kb and sata goes in MB
RunCore 256GB Pro IV 2.5" PATA IDE Solid State Drive SSD


US $82.00


















































